![]() So, keep that in mind the next time the remote is not working as intended. Usually, the replacement is not that hard to install, but you should refer to a professional if you’re not too sure about the installation routine.įrom there, it is pretty easy to get a consistent response from the unit. So, just get through the replacement, and you won’t have to worry about this issue. It won’t set back your budget, and you can easily improve the performance of your system. The upside here is that the receiver is pretty affordable. Otherwise, you’ll be running into the same error in no time. So, instead of trying to adjust its position or orientation, you need to improve the placement of the unit. Most of the time, the only way to get ahead of this issue is by replacing the receiver itself. So, be sure to look at the receiver to narrow down the issue. There is no point in only looking at the remote when trying to isolate this issue. One of the most common things that you need to consider here is the condition of the receiver. However, you can still hire an expert if you are trying to get through the fix. ![]() Ideally, this process won’t take much of your time if you’re a bit experienced in checking the electrical connection. So, to avoid electrocution, just remove the power before messing with the connectors. There is no point in putting yourself at risk while trying to save a few seconds. One thing to keep in mind is that you will have to remove all power from the main breaker before going through this step. Hopefully, the issue will be fixed right here, and you won’t have to bother with any more steps. Just make sure that the connectors are properly engaged and that there are no issues with the connection pins. You will have to clean them up a bit as well to get rid of the lodged debris.įrom there, you can adjust the response from the unit to avoid further errors. So, if you’re in this situation as well, just check the status of these pins. It is not too rare for customers to turn into situations with loose connectors. If you’re lucky, the issue will only be limited to the pin connectors. Similarly, if you are to reset your remote, you will have to turn off the power to the fan for around 3 minutes.Īs soon as you turn on the fan, you will have nearly 20 seconds for pressing 3,2 and 1 on the remote (should be this order) to reset. You can then proceed to turn on the power for your fan. Afterward, let it be turned off for at least 5-10 seconds while you reset the control system. In order to reset the fan, you will have to turn off your fan power. It could be that you are facing this issue due to a minor bug of any sort. If you would like to operate the fan with a hand held remote AND a wall control that will allow you to change the speed of the fan and dimming of the lights, you can purchase the Simple Connect Wall Control located on the wall control page.Doing so will help you in being able to restore all of the settings to default. Printable Receiver installation instructions will also be attached to your EMAILED RECEIPT once processed. The receiver board will install the same as the IT3/IT3-86 System Receiver Board shown in our Video Section on the Service / Repair Page of the Website. ![]() Instructions come with the new remote control showing all from installation to battery replacement. It MUST be purchased as a complete system to function, the receiver board alone will not work with any other universal switch or remote than what comes in this conversion kit. THIS ONLY APPLIES TO R MODEL, A MODEL AND Z MODEL FANS. This system can and will replace any remote controls such as W-21, W-22, W-62, W-63, W-64, & W-65. The standard on/off wall control with now control the main power to the fan. Customer will need to purchase a standard on/off wall control to replace the current Casablanca wall control. On the new hand held remote you will have Variable Speed Fan Capability along with light on/off and dimming quality. Casablanca Simple Connect Conversion System is a Variable speed Forward Only System there will no longer be an option for reverse with this system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |